Installation GUIDE

.points-covered

01

Thoroughly clean the wall surface that the Vetro+ product is to be installed onto. Use a trowel to evenly apply a neutral glass mosaic adhesive. Based on the pre-designed layout, stick on the tiles firmly and ensure equal spacing between each tile.

02

Upon sticking on the tiles, use slight pressure to evenly apply a sealant (a sealant with epoxy resin components is recommended) over the Vetro+ product surface, as this will enable the sealant to fill the spaces adequately. After this, use a scraper sponge to scrape off excess sealant before cleaning.

03

It is recommended that the sealant application be followed by the cleaning process (as cleaning will be very difficult once the sealant hardens). Do not attempt to fill the spaces for a large surface area at one go (work in a top-down fashion when filling spaces for a large wall surface). For cleaning, a clean water-soaked sponge should be used to lightly clean the surface area. Most of the excess sealant should come off with 2-3 rubs. To prevent stains from sticking onto the surface area again, please note that unclean sponges that have just been used for cleaning should not be used to clean the product surface area again.

04

Should you discover areas that are not fully cleaned upon completion of the tile installation, cleaning and sealant hardening processes, you may use a coarse damp cloth or plastic brush to clean the area again.

For detailed guidelines
please refer to the installation video
half-image
full-image
half-image
full-image
half-image
full-image
half-image
full-image
half-image
full-image
half-image
full-image
half-image
full-image
half-image
full-image
full-image
Back to Product List